February 2000 home August 1999 June 2000 December 2000 February 2001 March 2001 April 2001 May 2001 June 2001 September 2001 March 2002 October 2002 November 2002 March 2003 April 2003 June 2003 August 2005

Feb16/2000 - The front A-arms. Note the box like piece that is bolted to the holes on the spindles where the MacPherson struts were located
front suspension 2 Feb16/2000 - The front suspension viewed from front. I will be using rod ends instead of the tie rods shown in this picture.
pedal box Feb 16/2000 - This is a pedal box I put together that uses the stock RX-7 pedals. It has a bias-bar adjuster I fabricated along with 1 alloy Willwood master cylinder for the clutch and 2 Willwood compsoite cylinders for the front and rear calipers.
pedals Feb 16/2000 - Not much room for Daytons. (motorcycle boots)
rear 1 Feb 16/2000 - The IRS viewed from the drivers side. You can see the toe adjuster here that attaches to the hub and the rear part of the bottom A-arm.
rear 2 Feb 16/2000 - Waiting for some monster meats! (265x50x15 Hoosiers)
rear hub Feb16/2000 - This is the original Mazda alloy hub that was modified by a local race shop here in the GTA. I fabricated fake coilovers to set the chassis up at the correct ride height until I can afford some descent adjustable coilovers. I work accross the street from Dynamic Suspenssions, I gotta walk over there one day.
reartop Feb 16/2000 - The IRS from the top. This picture shows the long arms on the mazda differential and just how long the pinon extends into the chassis.