April 2003 home August 1999 February 2000 June 2000 Dec 2000 March 2001 February 2001 March 2001 April 2001 May 2001 June 2001 September 2001 March 2002 October 2002 November 2002 March 2003 June 2003 August 2005

	I have to relocate my twin MSD boxes out of the scuttle to where the battery is normally located in a seven. So I moved the battery as low as possible just below. These are all the original aluminum body panels cut to fit the modified chassis.
	I added some cross braces to the bottom of the shock tower mounts to the bottom of the opposite frame tubes. This will help transmit the load in compression to the opposite (unloaded) side of the car.
	There used to be 8 inches of wasted space between the back of that seat and the rear bulkhead. Now there is none.
	The cut and shut rear panel. OK so it has some rivets down the center. It still looks better than it's former wide butt self. As you can see, for now, no passenger seat. It no longer fits. I will need to cut at least 1" out of it's already narrow 15" width.
	Very very low. I'm going for just over 2" between the track and the bottom frame tubes. The new wheelbase is just under 89" down from just over 97". Front track is 56 3/4" and the rear track is 54 7/8". This is pretty much dead on to what I was aiming for.
	Got to start 'em young! This is my other autocross car I race and own with some friends.More info about it can be found here.